Well tonight I went and bought my new U Joints, Ball Joints and seals for the D60 axle.  I jacked the front end up and went to work. 

First I tore down the hubs and then removed all the inards of them. 

I had a little trouble getting the plate seperated from the nuckle but the air hammer took care of that.  I now have both axles lying in the floor and wow the passenger side uJoint was shot! I found needle bearings lying on the inside of the nuckle stuck in some grease.  Also on the drivers side the rotor was wably and not very tight.

So Now I have to replace the uJoints and figure out whats up with the rest of it.  I'm also gonna do some brake work up front.

No Pics tonight. hands where way to dirty for the camera.