Blog Entries Minimize
Print  

Blogs By Date Minimize
Print  

Search Blog Minimize
Print  

Blog    
Most recent blog entries Minimize
Started Build on Front axle
Wesley's Blogs Ftoy #510 By host on 11/29/2007 8:03 PM
Tore the front axle down to start building it.
More...
Ftoy on Rotisserie
Wesley's Blogs Ftoy #510 By host on 11/25/2007 9:00 PM
Put the Frame on the rotisserie so I could cut stuff off easier.
More...
Cutout and build these rear inboarded spring perches.
Wesley's Blogs Ftoy #510 By host on 11/21/2007 7:30 PM
Rear inboarded spring mounts designed and built.
More...
Built the rear crossmember.
Wesley's Blogs Ftoy #510 By host on 11/21/2007 1:25 AM
I started off by cutting out the original rear xmember then cleaned some frame.
More...
Air Tool Holder
Wesley's Blogs By host on 11/19/2007 5:22 PM
I snagged this idea from Millers Project gallery. Took about 20 minutes to build.
Comments (0) More...
Finished Cart with Shelf
Wesley's Blogs CNC Plasma By host on 11/19/2007 5:21 PM
I added a shelf to the cart for the extra accessories...
More...
Front XMember in place.
Wesley's Blogs Ftoy #510 By host on 11/19/2007 5:14 PM
I got the front spring hanger installed. I did it a little different than most . The length of the Ftoy frame should still be the same as it was before. It was either angle it like this or build out the Frame where I cut it short to get rid of the junk
More...
Built a cart for the plasma cutter
Wesley's Blogs CNC Plasma By host on 11/15/2007 2:49 PM
This isn't really directly related to the CNC table but it will hold the plasma cutter the CNC table will use. I built this cart last night out of scrap I had to cut apart and clean.
More...
Bender Update Finally.
Wesley's Blogs Bender Build By host on 11/15/2007 1:00 PM
I have had the bender finished for a while. Finally used it. I will calibrate the die's here soon for bendtech.
Comments (0) More...
Welp Here are my salvagable parts!
Wesley's Blogs CNC Plasma By host on 11/9/2007 12:51 AM
Well here is my start for the table. I am going to draw up the base this weekend so I can order some steel....
More...
Print  

  Home|Blog|Photos|Family|FToy|Guestbook
Copyright 2006 by Wesley Combs Terms Of Use Privacy Statement